Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hex file too large"
Pls help me! I was converted that code to hex using MikroC, but when i want put it into PIC. HEX FILE TOO LARGE. Pls someone tell me what is hapenning?
#define sw_up PORTE.F0
#define sw_down PORTE.F1
#define sw_enter PORTE.F2
#define relay_in PORTD.F0
#define relay_out...
Re: Please some help me.
thanks dude, i hope it can operate.
---------- Post added at 22:32 ---------- Previous post was at 22:31 ----------
im sorry, what kind of software that will use to convert that to hex file. im the beginner.
---------- Post added at 22:36 ---------- Previous post was...
hallo,can u help me? how to convert this language to hex file?
#define sw_up PORTE.F0
#define sw_down PORTE.F1
#define sw_enter PORTE.F2
#define relay_in PORTD.F0
#define relay_out PORTD.F1
#define led PORTC.F4
#define buzzer PORTC.F5
#define sec_flag flag.F0...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.