Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
I am new to HFSS 3D Layout. I watched a Youtube video showing that to create antipad, need to assign different net name. but when I did that and draw trace to connect the via hole, it doesn't show the via hole pad.
Hi.
The design is like through-hole for component where later we insert the desired component inside that, so that's why it does not have trace connected to it. The reason why am I asking is because I think the result may not be accurate as there is trace there. But I am also not sure about that.
Hi!
What should I do to remove the following WARNING which shows like this:
WARNING: Accuracy can be lost due to matrix compression, you can rerun the simulation
with reduced compression level or with the direct dense solver to verify the results.
WARNING: S-parameter data show unphysical...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
