Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi FvM, I have now updated the schematic. Well it is still not mine. I can run eda tool only at the university and I forgot to snap the top level of my design. I hope you understand my question. Do you think I have choosen the righ values for Vref and Vtrip? 8-O
My understanding is Vref = max of...
I am designing a 8 bits dual slope integrating ADC. The modules (integrator and comparator)are implemented with single ended output architecture with supply 0V to 1V. Its analog input signal range is .25V to .75V ie Vcm is 0.5V and vamp is 0.25V. My confusion is choosing right Vref and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
