Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You're right but the non working circuit is the real one. I have pics about it. But it is not clear.
1716136170
If I'm not mistaken, the result should be similar to this. I say this based on the simulink outputs I uploaded above. A signal going towards the reference, a little overshoot. And...
What is required from us is the step answer. However, I used this because I thought that the closest result to the step response in the laboratory environment was 1 Vdc or a pulse with a very high duty ratio. In the simulation I gave 1Vdc.How can I check the DC operation point exactly? Can you...
Here is my input signal. When I apply pulse to the input, I get the result I expect. But when I installed it on the board, which I tried many times, I couldn't get much.
The breadboard.
I tried it many times, but I did not encounter any results other than a very weak sine, noise or constant 12.4 Vdc. I think I overcame the Vdc problem by using a practical integrator, but I still can't get any results.
First of all, hello. I want your help with an assignment. The assignment given to me for the control systems course is to design a lead compensator. For this, I first need to design the circuit of the plant given to me. My plant is 5/s*(s+9).
For this, I first took my simulink output. Then, I...
I thought this and I did it today. But I have some problems. Firstly. I made a Schmitt-Trigger,and I integrated the output signals. So I have a triangular wave. And then I try to rectify the Triangular Wave. And finally I used a comparator. But my rectify circuit is include Op-Amps because when...
I am controlling duty cycyle R17 and R8. When I want to control frequency I am using pot U7. But when I change the duty my also my frequency changing and my circuit is not working stable. The circuit is have a voltage divider at the end. But this is not linear.
Regards, Ahmet.
As a project assignment, we were asked to design a signal generator. A variable amplitude between 80 mV and 2V. A variable frequency between 355 Hz and 3 KHz and duty between 10% and 90%.
As a result of my research, I found the Pulse section as follows. I have two problems. First, as the duty...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
