Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I want to draw BER vs. Eb/No on Advanced Design System (ADS) for QAM
I have problems in configurations of the blocks.
Can any one help me in this problem?
Thanks
Regards,
Ahmed Zaki
Hi,
1st: Thanks for replying
2nd: In my standard I wok on (IEEE 802.11n), it says that I should insert '0' in the decoding process.
And If I put don't care as you said, how can I ignore this bit in the decoding. The viterbi algorithm takes two bits for the decoding process.
Regards,
Ahmed Zaki
Hi all,
I understand how the Convolutional Encoder works, and I implement it using MATLAB and ADS.
When I get to design the decoder, I get more problems.
I understand its concept and the viterbi algorithm and the Trellis diagram.
My rate is 3/4 by Convolutional encoder with rate 1/2 and then...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.