Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Fluke megaohmmeter usage
Hi all,
I am using a FLUKE MegaOhmmeter to measure a the isolation of an isolation joint.
I want to know how does this device work to measure the resistance of the isolation joint (theory of work), I under stand it induces current and measures voltage throughwhich it...
in4004
but I am sure of the diode polarity and also the sourse,
I wonder if this type of diodes has low break down voltage so it conducts in the reverse direction???
in4004 diode
Hi,
I am working with a fire fighting system control panel, and I have a problem in the panel output.
the out should be connected to a solenoid to control opening the extinguisher as in picture
the diode is connected to prevent transients made by solenoid coil from entering cct...
you may take a snap shot by
1- opening terminal and writing the folowing command <xwd -out filename.xwd -frame>
this command is to take a snap shot and save it in filename.xwd.
2- just when you type this command and click on mouse the snap shot will be taken, so you can use...
thanks all, I made my latch using TSPC and it already works at 2.4GHz :D.......
but I want to know -generally and in clear words- the best cases for using CML, TSPC and any other latches......when I should use this or that ???
HI
I'm looking for a design for a level shifter to raise voltage level by 0.4 volts.....and works in high frequency.
If you please I need a link or a book that contains any design or explanation to this topic.
cml divider tspc divider
I used TSPC in my design and it worked well in frequencies larger than 8oo MHz, it is simple unlike CML, so I advise to use TSPC.
but I have another problem that my design requires DFF that works in 2.4 GHz and TSPC didn't work well in this frequencies and all designs...
when I use repetition codes, I may keep the same energy for transmitted bit, or the same energy for information bit: for ex.....if I repeat the bit 3 times, each bit from the 3 is sent with the energy that I would give for the original one.......or I may assign them energy such that their total...
Hi all,
I'm using cadence to design a cct, I drew the schematic but when I start the simulator (spectre) it takes
too long to open .... I don't know what the problem is?? can any one help??
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
