Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
can you suggest me a preamp circuit. i tried one with lm358 but didnt work. And i am a bit confused how to connect 3.5mm jack to the output. It would be very great if u pointed me the right direction.
I want to increase the range of my mic which i am using in my pc. Right now i am using a mic from torn from a headphone connected it directly to 3.5mm jack. but the range is very bad. Can i use a pre-Amp to to boost it. If yes then please suggest a preamp circuit which can be used with 3.5mm...
Ok then i will use your circuit. And i am using ir because i am making a remote control module to control tv from mobile. And as i asked can i use lm358 instead of lm386 in your circuit asi have the ic right now. Otherwise i have to go and buy lm386..
Thank u very much. I will try this circuit. But what resistance should i use for infrared led. And is there any problem if i try the circuit with lm358
Hey guys i am trying to aplify sound signal from my phone to glow LED(IR). i am using lm358 dual op amp. But i am haveing lots of problem. Like powering the ic, connemting ground and virtual ground n all. I am new to electronics. Plz sm1 hlp me make the circuit.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.