Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The effect of insufficient acceleration is very clear to see.
However
1. I am asking what is the effect of 0 deceleration
2. What is the min acceleration time up to 500RPM with no load.
3. My observation is: Motor can run up to 200 RPM with no acceleration and also it runs at 500 rpm with RC...
Thank you very much for all.
And thanks to Barry
My stepper driver is China's made, up to 6A and 1/250 micro step adjustable with dip switch. OK for me.
I cant find speed/torque/acceleration data.
Regards
Thank you.
My Motor is Soyo Nema42 SY85STH80-4208A Rotor Inertia 1400g-cm2, Detent Torque 1.2 Kg-cm and the load is 6kg.
However I am just trying without a load and see no more than 200-220RPM speed with no acceleration. First, what is the minimum acceleration tim up to 500-550RPM
Regards
Please let me know the acceleration time up to 500 RPM stepper motors. I also need deceleration time also. What was happening without deceleration time, is the motor jerk or slip?
Thanks
Re: Linear Ramp Circuit controlled by PWM
Thank you very much for your response. Please find the picture attached, it will be more clear.
- - - Updated - - -
Add picture
- - - Updated - - -
Add picture
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
