Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
welcome revni!
sht series are supported in proteus 7.6+ and can easily be simulated.
i didn't see any model for other, but u can smiulate them with varying caps or res (pot)[COLOR="Silver"]
hi
here u must perform a dc analyze like what u do in hspice:
after design yr circuit, add current probes for interested nodes.
add dc simulation icon to yr schematic and change its default settings.
for sweep, click on dc simulator and then click on tab button, add yr device and define sweep...
thnx man,
yeah its package is tqfp and needs pcb.
but if u want to test on breadboard, u can use an atmega8 avr and avr cdc firmware
yeah that's true, it adds a com port to yr pc.
but it convert usb to TTL serial, if u want 232 voltage level u must add a max232
also factory-built dongles with...
:(
hope not, but maybe it's damaged
yes, https://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT232BM.pdf is the official datasheet
it's very straightforward
if u r in tehran, i can send u one
i've tested all the ways, but aubtm always sends the similar periodic incomprehensible data.
i have a usb bluetooth usb dongle (for my pc) and a bluetooth equipped cell phone.
none of them could find aubtm.
i paid $3.5 (3500 toman) for FT232BL chip and bought it from javan electronic.
i've made...
tnx for yr attention
i'm using a ft232 usb<->serial dongle
isearched a lot and i think AUBTM is sending error periodically(as u said)
but i don't know why the data is incomprehensible for me.
i have tested everything from 1200 to 115200 baud rates but i can't get ERROR msg
i checked signal on...
thank you mr Ebrahimi gerami ;)
finally U SUPPORTed me, not the austar!
yr nice upload is the only right pdf in the whole net.
-------------------
EDIT:
but unfortunately i have the same problem as before!
when i connect the module to the serial port, it starts sending incomprehensible data...
If so, let all have the datasheet!
I have AUBTM-21 datasheet and External AT Commands but it doesn't help.
for example the pdfs doesn't explains about the default baud rate.
or information about how to connect RESET pin, the user must find it through try and fail!
when i pull up the RST to vcc...
these modules are very bad and have no support from austartech.com
i have searched a lot to find how to connect it pins but i didn't find any useful datasheets.
in the other hand its chinese company didn't respond my emails.
i have bought it abt $40 and i don't know how to run it!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.