Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I see you guys have been discussing the diode I choose, the 1N270. I believe it is a functional germanium diode as evidenced by this video:
https://www.youtube.com/watch?v=n3IeDz5yCSk
I know there are better models out there but I need a little bit of help before I go shopping.
I know a silicon...
Thanks srizbf,
I was under the impression that the modulated signal could not induce oscillation in my circuit's current unless it had a sufficient drain for the charge be absorbed by, thus ground.
Perhaps I did not understand your point, could you please clarify?
Thanks for your time,
Admiral
Hey Brian and thanks for the thought out response.
I neglected to inform you that the top of the coil's turns have been sanded to remove the top layer of enamel. Also I and took care to make sure the exposed wire did not connect between turns. The shiny band on the coil in my picture is not...
Hello, I am a self-taught electronics hobbyist and I've been on a mission to understand radio transmissions. I've started with some simple crystal radio circuits and have had some success. Recently I attempted to build the circuit below:
This is my fully assembled attempt:
My ground in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.