Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the motor voltage is 36 Vdc and its resistance is 4.1 Ohms
- - - Updated - - -
i did not tested it when the motor runs , but it get hot when tested alone , i guess the encoder sensor is the problem " I checked the Optical Encoder Module " HEDS-9731 " , and when i tested it , i connected...
I checked the Optical Encoder Module " HEDS-9731 " , and when i tested it , i connected 5.12v to Vcc and 0v to GND , the output from Channel A and Channel B is always 5.02 v even when i close the LED path , whats the problem please ?
Hello every one , greetings from Egypt , I have a servo motor controlled the x-axis motion of a wide format solvent printer , yesterday , it stops suddenly and it was free to move , i replaced it by a new one and the printer worked fine , Now i want to get it working again ;) , the encoder...
hi everyone , I need to control the phase angle of a 3-phase full wave rectifier using thyristor and a microcontroller (like 16f877a) and a LCD module so , if anyone have a useful data "layout - simulation files - Mikroc code " please replay . Thanks all
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
