Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by adam79416

  1. A

    reference resistance in adc design

    " want to parallel resistance to gain a little and accurate one" If u dont concider the area of the circuit.
  2. A

    have any PDA CAD tool can reading GDS file ??

    convert gds to dxf Yes of cause u can. Try mideaplay.
  3. A

    PFM modulator of Buck regulator

    buy some books to learn,ok?
  4. A

    What are the steps for Diva LVS?

    The problem of diva lvs U should find these unmatched error. some error is not as same as the specification. ur steps r right.
  5. A

    Power line width for oscillator layout

    power line width What is the process u choosed? about 1-2um/mA. Added after 5 minutes: Only a OSC consumes 10mA? CMOS or BIpolar? too huge. maybe u should modify ur circuits.
  6. A

    Need startup circuit for self-bias voltage/current reference

    Maybe u can open a chip to see. Any start-up circuit "works to make the main circuit start then after that it consumes no power ".
  7. A

    Pls me a low voltage low power high gain OpAmp

    obtain 3 points. good luck.
  8. A

    how to use calibre RVE

    rve + calibre Use cadence Vortoso
  9. A

    what is your favor drawing software?

    I used Photoshop. good choise. have a try!
  10. A

    Zero current detector of Buck regulator

    zero location buck regulator good topic. Very good.
  11. A

    ULTRA HIGH SPEED COMPARATOR

    ultra-high-speed comparators GaAs? I dont think so. The frequency is just 500MHz
  12. A

    A question about ring differential oscillator

    yes , u r right. Added after 1 minutes: M24 is in the wrong . u should check the bisa voltage
  13. A

    Help me measure INL and DNL in Hspice (memory issues)

    hspice question good topic. but i just wanna some point.
  14. A

    comparison of CMOS and BJT

    I am looking forward the answer of the question upstairs. what is the LinMOS?
  15. A

    Help new beginner to learn analog ic design....

    If posible, u can learn to read layout,and then u can do some simulation on simple circuits.
See more

Part and Inventory Search

Back
Top