Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What's the output of this op amp circuit? Consider the 1V source as just V. Could someone give me the working & description of this circuit with relevant expressions?
Thanks! I was fiddling with TA1 while checking the TA0 pin. Just one last question.
Do the +V & the Signal pin of the servo need to work at the same voltage levels for proper operation or can the signal be 3.3V while the +V be 5V?
I'm trying to control a TowerPro SG90 servo from my ez430-rf2500 board. I'm able to configure the Timers for PWM operation but there's absolutely no response from the servo. Just a small jerk at start and nothing.
As far as the connections are concerned, I've connected the grounds of ez430...
Thanks for the reply.
The thing is, the camera circuit must merely capture the video & transmit it off to the receiver display circuit. Its like, the transmitting circuit merely "dumps" the camera output to the receiver. The conversion from analog(PAL/NTSC) to digital must take place at the...
Hi, I'm trying to transmit data(video) from the mini CCTV camera given in this link-
**broken link removed** over RF to a LCD display circuit.
I don't need the processor in my circuit to do any sort of manipulation with the video. The camera outputs in PAL/NTSC format & this output should be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
