Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
When I'm writing out the SDF from P&R tool, the timing checks are split into Setup and hold, recovery and removal. I want this to be grouped under setuphold and recrem arcs respectively.. Can anyone please help me out on fixing this.
Thanks in advance,
Abhinay
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.