Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ADS analyze the electronic circuits based on harmonic analysis whereas Hspice analyzes electronic circuits based on transient time and Time domain... and thus, each one has it own power. ADS is more useful for high frequency and frequency analysis, while, the hspice is more accurate when you are...
Hi again every body, Actually, I have simulated my FDA using LT spice. My question is that the configuration for input noise source and differential output is right or not ? I have attached the circuit for input and output as below.
I am still waiting to hear from you guys.
Hello everybody
Actually, I have designed a fully differential amplifier like the attached picture. Actually I have simulated all parameter in DC and AC, the only parameter which I could not simulate and also it is the most important one, would be Noise figure. the main problem is that how to...
Hi every one, this post is one of the most oldest post in this forum , but nobody answered the author clearly, actually I have faced with exactly the same problem , dose any body no about removing those three line in order to working correctly this type of commands??? and is any other way to do...
Hello everyone, I got a problem when I was calculating the voltage of circuit below. Assume that Vin is equal to zero so that TP and Tn2 are on and in non-saturated and saturated regions respectively. Moreover, Tn and Tn1 are off. it was written that the voltage of Vdsn1 is equal to ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
