Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can use a CP to generate the higher voltage. However, you'll need a regulated 3x charge pump so you can get 1.2V off the 0.4V unregulated, and 1.0V regulated including switch losses etc. It would take area, as you need the switches and either on-chip capacitors (flying and reservoir) or...
autosave in cadence
1. Instead of printing the op on the schematic itself, you can get it to print it in a new text window.
2. In ADE -> Outputs -> Save All -> select the relevant bits you want to save.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
