Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey there,
I wouldn't expect VBA code from Excel to work in the general case in HFSS, I'd check out the .pdf scripting guide's examples -- something that's really useful for getting started if your end goal is to manipulate the HFSS project is to record your UI interactions to VBScript through...
Hi All,
If one is setting up a parametric sweep in HFSS, you can check "Copy Geometrically Equivalent Meshes" in the last page of the parametric sweep to simulate without re-meshing each time.
However I think this is more of an XY problem and Volker has the right answer, there's no reason to...
Ditto on the fact that the first port is likely too long and skinny.
I'd reduce the size of it, and also make sure you're putting a radiation boundary on the outside of the sol'n region, and checking the "Use Radiation Boundary on Ports" option under the advanced tab of your sol'n setup.
Hi,
'r' in this case would be the distance between the phase center of your antenna and a point in the far field.
Note that in the far field, electric field falls off with 1/r, so when you multiply by r, the entire quantity r*E is no longer dependent on r, but instead just on phi and theta...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
