Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Doesn't the Eigenmode solver require resonant frequencies? As it is a parallel plate capacitor, the resonances do not seem like they would be realistic (i.e. the inductance would be incredibly small).
Concerning the calculation, I think this is the crux of my question, how do I go about that...
Thanks for the clarification question.
My apologies, there were actually three related questions there, however the primary question is:
How does one calculate the fringing capacitance separate from the simple averaged parallel plate capacitance using HFSS (calculator or otherwise)?
You can...
Hello All,
I was wondering if someone might be able to help me determine the fringing capacitance due to a parallel plate with an extended dielectric?
My test project (attached below) is just a simple two parallel plate setup with a Lumped Port connecting the two at the center of the two...
Hello all,
I am wondering if someone could help me with designing a 5th Order Butterworth LPF using a Switching Capacitor topology in NI Multisim 13.0?
I am trying to replicate a design used in "Design with Operational Amplifiers and Analog Integrated Circuits" by Sergio Franco in Figure 4.33...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
