| Author |
Message |
digitallan
Joined: 11 Jul 2001
Posts: 24
Location: Turkey
|
 13 Oct 2001 10:32 |
|
|
|
hello
i want to make keyboard cable 10m.
how can i strengthen the signal ?
Does anybody have information about how to design this . any article, hint or design will be gratefully .
thanks.
|
|
| Back to top |
|
 |
Kalashnikov
Joined: 11 Jul 2001
Posts: 16
|
| 13 Oct 2001 12:25 |
|
|
|
I don't think you'll need to amplify
the signal if you use _good quality_
shielded cable. I've gone up to 50 feet
in the past with no problems. Of course
your mileage may vary and not all PC's
are built the same.
Kal
|
|
| Back to top |
|
|
digitallan
Joined: 11 Jul 2001
Posts: 24
Location: Turkey
|
| 13 Oct 2001 19:06 |
|
|
|
but i really need this circuit becuse i used the good quality shielded cable. if you have any information about amplifing signal and also i connect to cable(10m) my mouse is locking if you know why should be
you will be gladden me.
|
|
| Back to top |
|
|
Alexg
Joined: 14 May 2001
Posts: 51
|
| 14 Oct 2001 1:46 |
|
|
|
Ok... Let's see..
First of all power your mouse or keyboard from another power supply independent from the micro and that alone might solve you problem. If not you will have to put some open collector drivers on the output from the Keyb. or mouse and you can try a cmos schimtt trigger on the input but even that might not solve the problem and you will have to put a buffer on the pc side also. Better try out a heavier cable with bigger wires and better shielding.
Best regards,
Alexg
|
|
| Back to top |
|
|
