| Author |
Message |
myem
Joined: 12 Dec 2003
Posts: 132
|
 26 Dec 2003 2:41 a good inductance |
|
|
|
dear all ~
How to distinguish from quality of a high frequency inductance ???
|
|
| Back to top |
|
 |
flatulent
Joined: 19 Jul 2002
Posts: 4856
Helped: 292
Location: Middle Earth
|
| 26 Dec 2003 4:30 Re: a good inductance |
|
|
|
| It should have a published data sheet value. If it is one you make, keep it air all over with the stiffness of the wire to hold its shape. Use wire with lots of surface area (large diameter wire) and have the spacing between turns about the wire diameter to keep the parasitic capacitance down.
|
|
| Back to top |
|
|
myem
Joined: 12 Dec 2003
Posts: 132
|
| 26 Dec 2003 7:39 Re: a good inductance |
|
|
|
| flatulent wrote: |
| It should have a published data sheet value. If it is one you make, keep it air all over with the stiffness of the wire to hold its shape. Use wire with lots of surface area (large diameter wire) and have the spacing between turns about the wire diameter to keep the parasitic capacitance down. |
dear sir:
We always talk about the Murata inductance is good.
OK.....
How do we know the inductance is good or no good???
what parameters of inductance are the most important for a inductance ??
|
|
| Back to top |
|
|
AL0117
Joined: 25 Jul 2003
Posts: 230
Helped: 8
Location: dracu-la-nd
|
| 26 Dec 2003 9:17 Re: a good inductance |
|
|
|
Hi ,
The most important parameters of an inductor are:
-inductance (measured at a certain frequency)
-Q
-SRF (self resonant frequency)
Also there are some more: tolerance, DCR (direct current resistance), etc
Serch the forum for the book :RF circuit design / by Chris Bowick in chapter 1 you will find some explanations about inductors. Also you could read the following apps from Coilcraft:
hxxp://www.aade.com/lcm2binst/coilcraft%20L%20measurement.pdf
hxxp://www.eetkorea.com/ARTICLES/2001AUG/2001AUG27_ICT_AN.PDF
(replace x with t)
You can decide which parameters are important for you based on your application
rgds, Al
|
|
| Back to top |
|
|
flatulent
Joined: 19 Jul 2002
Posts: 4856
Helped: 292
Location: Middle Earth
|
| 26 Dec 2003 18:06 Re: a good inductance |
|
|
|
| Sorry for getting carried away and leaving out the second sentence that would have said to look for the Q and SRF values in the data sheets. The best commercially available inductors are made as I described. Coilcraft makes ones such as this.
|
|
| Back to top |
|
|
