| Author |
Message |
wolverine123
Joined: 05 Feb 2009
Posts: 11
|
 03 Nov 2009 17:19 STEPPER MOTOR PROBLEM |
|
|
|
|
Hey guys i'm trying to interface a unipolar stepper motor with a 89s52 and the program runs fine in proteus, now the problem i'm facing is that when the pin is high from the controller this should invert the signal and move the stepper motor but my problem is in hardware, when i check the controller through DMM i see i'm getting 3 to 5V from the output pin of the controller but when i connect a jumper to the uln2003A the voltage goes down to 1V or 1.7V and doesnt work. Without connecting the inverter its fine, can anyone please tell me why is this?? and i have used the following fig to just connect the stepper motor
|
|
| Back to top |
|
 |
Google
AdSense
|
03 Nov 2009 17:19 Ads |
|
|
|
|
|
|
| Back to top |
|
|
nandhu015
Joined: 11 Feb 2006
Posts: 641
Helped: 46
Location: Tamilnadu, India
|
03 Nov 2009 17:39 STEPPER MOTOR PROBLEM |
|
|
|
|
uln2003 consumes more current than 89s52 can sink.
Use a resistor more than 10k from 89s52 to uln
|
|
| Back to top |
|
|
dimas_lilik
Joined: 13 Aug 2007
Posts: 53
Location: Indonesia
|
10 Nov 2009 14:01 STEPPER MOTOR INTERFACE PROBLEM |
|
|
|
|
I have been using the ULN2003A, but I always pin 10 open.
What a difference 10 ULN2003A pin in the open and let the connecting pin 10 with vcc
Such series I have ever tried, but the motor is not strong, My STEPPER motor 0.45A. after I replace it with L297, until now a good motor
|
|
| Back to top |
|
|
hameeds01
Joined: 23 Aug 2005
Posts: 308
Helped: 15
Location: NUST Islamabad
|
10 Nov 2009 14:40 Re: STEPPER MOTOR INTERFACE PROBLEM |
|
|
|
|
| hey u r driving ur stepper motor via 7805 thatz not fair, use a saperate 6v supply to drive ur stepper motor
|
|
| Back to top |
|
|
anandpv2009
Joined: 11 Aug 2009
Posts: 63
Helped: 4
Location: India
|
10 Nov 2009 19:26 Re: STEPPER MOTOR INTERFACE PROBLEM |
|
|
|
|
Tips..
Use 8 to 12v supply for stepper motor, not from 7805. The maximum current that can flow through 7805 is 1A.
Use same supply for motor and ULN2003 (Max 15v)
|
|
| Back to top |
|
|
wolverine123
Joined: 05 Feb 2009
Posts: 11
|
11 Nov 2009 9:39 STEPPER MOTOR INTERFACE PROBLEM |
|
|
|
|
i didnt use the 7805 i just used the stepper motor connections, anyway thanks nandhu, the resistors worked 
|
|
| Back to top |
|
|
