electronics forum

Rules | Recent posts | topic RSS | Search | Register  | Log in

problem with 5.8GHz video downlink range


Post new topic  Reply to topic    EDAboard.com Forum Index -> RF, Microwave, Antennas and Optics -> problem with 5.8GHz video downlink range
Author Message
guzak



Joined: 02 Jul 2009
Posts: 1


Post02 Jul 2009 18:33   

video downlink


Hi, I have one question for somebody experienced with 5.8GHz video downlink. I am using RC helicopter for aerial photography and I bought RF-Link AVS-5811 5.8 GHz video T/R kit for checking camera view on the ground. Unfortunately transmission range is very short and I would like to ask, if there is possibility to use some kind of dirrectional antena for receiver or amplifier for transmitter signal.

Thanks
guzak(at)azet.sk
Back to top
Google
AdSense
Google Adsense




Post02 Jul 2009 18:33   

Ads




Back to top
kspalla



Joined: 19 Aug 2008
Posts: 848
Helped: 140


Post06 Jul 2009 13:38   

5.8ghz rc


Directional antenna may not solve your prob.
You need amplifier.
Back to top
biff44



Joined: 24 Dec 2004
Posts: 1835
Helped: 244
Location: New England, USA


Post06 Jul 2009 23:15   

downlink aerial photography


Well, obviously if you increase the transmit power or use a directional receive antenna (pointed at the RC), you will get better range. You could attach the some sort of yagi antenna to the bottom of your controller, and always point it toward the
RC model.

IF you were going in one general azimuth away from your position, you could mound a high gain receive antenna on a tripod.

Your problem with the transmitter is that most countries will limit the transmit power you can use at 5.8 GHz.

You do not mention how you are sending the video, but there is a lot of processing stuff you could do to it. You could mpeg 4 encode it to get the bandwidth down, and then send it with the simplest modulation type you can get (like BPSK). This will give you more system link margin.

Rich
Maguffin Microwave LLC
www.MaguffinMicrowave.com
Back to top
Arabic versionBulgarian versionCatalan versionCzech versionDanish versionGerman versionGreek versionEnglish versionSpanish versionFinnish versionFrench versionHindi versionCroatian versionIndonesian versionItalian versionHebrew versionJapanese versionKorean versionLithuanian versionLatvian versionDutch versionNorwegian versionPolish versionPortuguese versionRomanian versionRussian versionSlovak versionSlovenian versionSerbian versionSwedish versionTagalog versionUkrainian versionVietnamese versionChinese version
Post new topic  Reply to topic    EDAboard.com Forum Index -> RF, Microwave, Antennas and Optics -> problem with 5.8GHz video downlink range
Page 1 of 1 All times are GMT + 1 Hour
Similar topics:
short range wireless video (9)
Confused over PLL lock range, pull out range, pull in range. (1)
wide tuning range VCO problem (8)
microcontrollers KeilC - starting address and range problem (2)
plz help me: IR remote control & receiver range problem (9)
Video Protecion Problem (2)
help with increasing range of tx/rx (1)
about PLL acquisition range and tracking range... (5)
Case range with bitstream: VHDL (1)
Sony KV32S40 Flashing Video problem (1)


Abuse || Administrator || Moderators || Support us || sitemap
topic RSS