How to make co-simulation optimization effictively in ADS?

EDAboard.com Forum Index -> RF, Microwave, Antennas and Optics -> How to make co-simulation optimization effictively in ADS?

Author

Message

John_li

Joined: 06 Aug 2005
Posts: 210
Helped: 8

14 Oct 2008 23:47 ads simulation optimization

Hi all,
I designed wilkinson divider using ADS.I have run optimization,and get the result that i want(current EF=0) in schematics.But when i did co-simulation,the result can not meet the specification.What should i do in the next step?Because the optimization of schematics is OK.

kspalla

Joined: 19 Aug 2008
Posts: 848
Helped: 140

15 Oct 2008 4:23 How to make co-simulation optimization effictively in ADS?

Have you placed compleate transmission line with 5 port in layout? then export to layout look like after parametrization. Place the 100 Ohm resister. Then optimize.
I am sure that you will get zero error function.

Google
AdSense
Google Adsense

15 Oct 2008 4:23 Ads

John_li

Joined: 06 Aug 2005
Posts: 210
Helped: 8

15 Oct 2008 23:04 How to make co-simulation optimization effictively in ADS?

Yes.I placed 3 ports in input and output termimals,and the other two ports to isolation resistor.and export to look alike.I do not know whether ADS has optimization funtion of microstrip in co-simulation?
Another question,whether can i add a resistor in layout,and directly tune the microstrip before Co-simulation?Can you tell me how to add it in detail?
Thanks

kspalla

Joined: 19 Aug 2008
Posts: 848
Helped: 140

16 Oct 2008 3:58 Re: How to make co-simulation optimization effictively in AD

Quote:

Another question,whether can i add a resistor in layout,and directly tune the micro strip before Co-simulation?Can you tell me how to add it in detail?

Lumped resistor can not be placed in Layout. You can place the discrete component having W*L*H and you know the resistivity etc. its a long process so recomend to use schematic.

Quote:

I do not know whether ADS has optimization function of micro strip in co-simulation?

Do you know parametrization in Layout? if not go through the help.
You need to parametrize the 75 ohm length and width to get EF=0. If you export to schematic with layout look like then you will find these parameters in the schematic component.

John_li

Joined: 06 Aug 2005
Posts: 210
Helped: 8

18 Oct 2008 1:43 How to make co-simulation optimization effictively in ADS?

Dear Kspalla,
Thanks for your reply.The first time using parametrization in Layout,and i use ADS2008 online help.I try to find some documents about parametrization.unfortunately,i can not find none.I do not know how to find the subject.Can you help me generate the subject into PDF format,and send it to me:John_li3000(at)sohu.com?
Thanks,
John

kspalla

Joined: 19 Aug 2008
Posts: 848
Helped: 140

30 Oct 2008 6:16 How to make co-simulation optimization effictively in ADS?

You can get the detailed help from the installed folder C:\ADS2008\doc\mom\ads2008\Layout_Components_for_Momentum.html if it installed in C drive.
Let me know if you still has problem.