FvM
Joined: 22 Jan 2008
Posts: 2632
Helped: 431
Location: Bochum, Germany
|
 27 May 2008 23:01 Re: Generate Ethernet frame |
|
|
|
I notice, that you're rescheduling your request cause no one answered. To my opinion the question is almost clear, at least generally, but apparently there are no comments. I fear, this is basically cause topic may be to special.
Perhaps you should show more clearly, where you expect problems or what you already found out about the basic options. Also some specifications would help, e. g. what's the intended timing resolution.
I wonder, if some standard network controller would allow to adjust interframe gap. I expect, that they keep a certain timing internally when scheduling multiple frames in full-duplex mode out-of the FIFO. Did you systematicly check the specifications?
I'm also not fully clear about the specification side. I think 96 bit times are used for the slower standards.
Assumed, standard network controller hardware won't allow a sufficient frame gap control, then a software controller in a FPGA could be expected to be flexible enough?
|
|
