| Author |
Message |
lsy2004
Joined: 24 May 2004
Posts: 36
Location: US
|
 26 Mar 2005 21:33 help in protel dxp : problems in generating Gerber file |
|
|
|
|
Hi,
I need helps with Protel DXP. How can i generate gerber file ? I used " fabrication output: gerber file", it would have the file with extension *.Cam. When i imported itwith gerber view, nothing. Does anybody know how to solve it?
Thanks.
|
|
| Back to top |
|
 |
Google
AdSense
|
26 Mar 2005 21:33 Ads |
|
|
|
|
|
|
| Back to top |
|
|
jdhar
Joined: 16 Aug 2004
Posts: 261
Helped: 13
|
26 Mar 2005 23:55 help in P*otel dxp : problems in generating Gerber file |
|
|
|
|
| In the CAM file, go to export, and gerber files. Also, you should look i nte directory 'project outputs for xxx'... it usually generates gerbers in there automatically.
|
|
| Back to top |
|
|
House_Cat
Joined: 21 Feb 2002
Posts: 1507
Helped: 307
Location: USA
|
27 Mar 2005 2:50 Re: help in protel dxp : problems in generating Gerber file |
|
|
|
|
If you went to fabrication output, and selected Gerber files, filled out all the appropriate boxes, and checked tha appropriate boxes, you DID generate Gerber files.
If you are using DXP2004(SP1 or later), the files will be found in the project directory for your board in a sub directory called "Project Outputs for xxxxx", where xxxxx is the name of your project. If you are using an earlier version of DXP, the files will be in your documents directory - you'll have to hunt for them.
The .CAM file you think you see is just the default file extension that would be saved from CAMTASTIC. You apparently have CAMTASTIC set up to open automatically when you generate gerbers. This display is just for you to check - it doesn't change the gerber files you have in the directory I mentioned above.
Use your operating system browser, and you'll find that all the necessary files are there on your hard drive.
All of this is discussed under Help>Contents>PCB Fabrication and Assembly.
|
|
| Back to top |
|
|
