spit
Joined: 29 Mar 2002
Posts: 52
|
 21 Dec 2004 17:13 loading a traxmaker file into DXP 2004 |
|
|
|
|
Hi all,
previously I have always been able to load Traxmaker file (*.pcb) into Protel ( Protel DXP) and then select which component I wanted put it into a library, or I could just the better routing features of Protel. When I tried the same thing with DXP 2004 it loads it up no problem, but now I can't select any of the components, which is to sngle click to make them highlighted. Doubling clicking brings up the property on that particular component properites. I really don't much about DXP 2004, I am obiviously not setting something which would allow the component to be selected.
Any help would be most welcomed.
Thanks in advance.
spit
|
|
House_Cat
Joined: 21 Feb 2002
Posts: 1507
Helped: 307
Location: USA
|
14 May 2005 7:17 Re: loading a traxmaker file into DXP 2004 |
|
|
|
|
When you double click on the component and open the properties, look at the checkboxes on the left side of the screen. If "Locked" is checked, you will not be able to select the component with a single click.
Be sure to leave "Lock Primitives" checked to prevent accidentally modifying the footprint. Uncheck "Locked" to allow selection, moving, updating, etc.
|
|
